Fan Controller by 741
The amplifier gets quite hot while in use, so decided to use a fan to cool it. The fan, however, adds a lot of noise. To get the best of both worlds, I thought I’d turn the fan on only when required. The circuit shown uses two forward-biased diodes, one as a sensor diode (at JP2) and the other as a reference diode (D2). The small difference in forward voltage drop is amplified by IC1 and used to drive T1. T1 turns on a fan when the temperature on the reference diode exceeds that at D2. D1 prevents inductive kickback from killng T1. B1 and C2 provide a rectified, regulated supply from the transformer’s auxiliary 12V winding. This prevents noise from the fan motor getting coupled to the rest of the amp.
R1 is used to adjust the temperature cutoff point. This is done by first adjusting it to remain permanently off (turn it both ways, whichever way causes it to turn off, turn it all the way there). Now let the amp run for a while at a reasonably loud volume, so that the output devices heat up. Now place the reference diode on the heatsink of the output devices and back down R1 until the fan just turns on. Make sure that the fan is positioned such that after a while, it cools down the output devices enough to turn itself off.
Read more : Fan Controller by 741
Other circuits
Auto-Fan, automatic temperature control by 741 This circuit was designed to automatically activate a set of three or four small DC fans to cool a large cool-rib for a 10 Amp powersupply. Can be used in a variety of other applications as well……….More
versatile tone control by ic 741 This tone control circuit. A circuit design feedback tone control. This helps the smooth bass voice circuit and a rate increase – reduction of the signal at 18 dB………More
Op-amp siren sound using ic 741 This circuit is the sound generator super siren, for use be alarm signal get by live frequency generator circuit that use , op-amp circuit……More
Audible Light Sensor by IC 741 This is audible light sensor circuit that is based the IC741 op-amp IC. This circuit light sensor one,these are use two LDRs for detector lower lightly.
The 741 is pulse oscillator generator output to small speaker……More
bargraph light meter with ic 741 If you want simple meter the intensity of the light in a simple way. This circuit is very interesting, because with a LED display with 5 levels.The main equipment is uA741 the most popular op-amp circuit,…….More
PIC DS1820 Thermometer This application shows how to use the PIC16F877 to control, and interface with the Dallas DS1820 1-Wire Digital Thermometer……..More
Level Detector by IC LM741 This circuit be the circuit checks voltage is easily. Or Level Detector by IC LM741 highly popular. By R1 keep fine the value voltage referable of the circuit. If Vin be valuable more than volt. The referable LED stick bright…….More
Bridge Amplifier using ic LM741 This is circuit Bridge Amplifier by LM741……More
